سیستم تزریق رزین اپوکسی در حوزه صنعت دریا(Infusion Epoxy Resin system)

این فایل pdf  شامل ۵ صفحه مطلب جامع و کامل پیرامون محصولات پلی استری و کاربرد های آن در صنعت دریایی می باشد .

The standard procedure of working with epoxy systems applies this system. The 1040/1045N/1048N can be applied by brush, roller, infused or injected. In case of laminating over a cured surface without peel ply, it is required to deglaze, clean and degrease the support prior to laminating. It is recommended to have workshop temperature conditions between 18-25°C in order to facilitate the mixing and the reinforcement fibers impregnation. A lower temperature will increase the viscosity of the mix as well as it’s pot life. On the contrary, a higher temperature will reduce the viscosity and the pot life of the mix.